The IOLB-8108 has eight digital points, each of which can be operated as an output and is connected to an IO-Link Master.
The outputs handle load currents of up to 0.5A, and although the total current is limited to 4A, they are short-circuit proof and protected against inverse polarity. The state of each signal is indicated by means of LEDs. The signals are connected via M8 connectors.
The small IOLB-8108 form factor (H126 x W30 x D26.5 mm) means that they are suitable for use where space is at a premium. The small mass of the IOLB-8108 module facilitates applications with mobile I/O interface, for example, a robot arm.
The robust design of the IOLB-8108 module enables them to be used directly at the machine. Control cabinets and terminal boxes are now no longer required. The module is fully sealed and therefore ideally prepared for wet, dirty or dusty conditions (IP67).
Pre-assembled cables significantly simplify IO-Link and signal wiring. Very few wiring errors are made, so that commissioning is optimized. In addition to pre-assembled IO-Link, power and sensor cables, field- configurable connectors and cables are available for maximum flexibility. Sensors and actuators are connected through M8 connectors.
- X1 protective cap
- Point labeling tabs